300m FM Transmitter

This fm transmitter circuit is very simple and it has a acceptable transmission . The signal transited from this fm transmitter circuit can be received at almost 300 meters in open air .The circuit require a 3volts operating voltage and can be tuned anywhere in the FM band.The coil should be about 3mm in diameter and 5 turns. The wire is tinned copper wire, 0.61 mm in diameter.

300m FM Transmitter Circuit diagram

After the coil in soldered into place spread the coils apart about 0.5 to 1mm so that they are not touching. If you don’t have a trim cap you can use a fixed value capacitor and you can vary the TX frequency by adjusting the spacing of the coils or placing a small piece of ferrite inside the coil , but the better way to change the transmission frequency is to use a variable capacitor .Connect a half or quarter wavelength antenna (length of wire) to the aerial point. At an FM frequency of 100 MHz these lengths are 150 cm and 75 cm respectively.

Read More..

Miniature FM Transmitter

Miniature FM Transmitter Circuit Diagram 

Notes:
The default for the capacitors type is ceramic, preferably the npo 1% (low noise) type or equivalent. But basically nothing critical here. Use any capacitor you have laying around, but NO electrolytic or tantalum caps. Only if you intend to use this circuit outside the home you may want to select more temperature stable capacitors.

To find the signal on your receiver, make sure there is a signal coming into the microphone, otherwise the circuit wont work. I use an old mechanical alarm clock (you know, with those two large bells on it). I put this clock by the microphone which picks up the loud tick-tock. Im sure you get the idea... Or you can just lightly tap the microphone while searching for the location of the signal on your receiver.

Read More..

300m FM Transmitter

This fm transmitter circuit is very simple and it has a acceptable transmission . The signal transited from this fm transmitter circuit can be received at almost 300 meters in open air .The circuit require a 3volts operating voltage and can be tuned anywhere in the FM band.The coil should be about 3mm in diameter and 5 turns. The wire is tinned copper wire, 0.61 mm in diameter.

300m FM Transmitter Circuit diagram

After the coil in soldered into place spread the coils apart about 0.5 to 1mm so that they are not touching. If you don’t have a trim cap you can use a fixed value capacitor and you can vary the TX frequency by adjusting the spacing of the coils or placing a small piece of ferrite inside the coil , but the better way to change the transmission frequency is to use a variable capacitor .Connect a half or quarter wavelength antenna (length of wire) to the aerial point. At an FM frequency of 100 MHz these lengths are 150 cm and 75 cm respectively.

Read More..